CHAIN ACTUATOR QUASAR

Chain actuator QUASAR is available in both a 24V DC and a 230V AC version. This version has a fixed, non-adjustable stroke of 500mm. and a maximum push/pull force of 300N. Applicable to windows and vents for natural ventilation. The 24 Volt DC version complies with EN12101-2 and is therefore also suitable for use in natural smoke and heat extraction (N-RWA) systems.

The QUASAR has a die-cast aluminum housing (47.5x32mm.) which is available in gray, white or black version.
An advantage of this chain actuator is that the output of the chain is located in the center of the housing. This allows the motor to be mounted exactly in the middle of the sash.

This chain actuator is standard equipped with an automatic 0-point detection in closed position. This eliminates the need for mechanical adjustment.
The start position, end position and overload protection are electronically controlled.

• SYNCHRO version - For use of several motors (max. 4 units) on 1 wing.
• F-Contact - For feedback signal in both open and closed position, for example to control an extra bolt or hardware drive.
• DRAWBRIDGE version - This has a special chain guide to open bottom-hung windows 90 degrees for SHEV installations. (= on request)

If the stroke of 500mm. is not sufficient, please refer to the QUASAR-L chain motor.

ATTENTION:
The standard version is supplied including a fixed connection cable of 1.5 mtr.
The mounting brackets must be ordered separately. (Model depends on the situation / profile and application)